Technical Data; Safety Information; Proper Use - EINHELL Bavaria BET 30 E Bedienungsanleitung

Anleitung BET 30 E_SPK1:Anleitung BET 30 E_uebers
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
The corresponding safety information can be
found in the enclosed booklet.

1. Technical data

Power supply 230 V ~ 50 Hz
Shots per minute
Staple width
Staple length 15 - 25 mm
Staple thickness 1.1 - 1.25 mm
Nail length 15 - 32 mm
Nail thickness 1.1 - 1.25 mm
Weight
Totally insulated
Sound pressure level L 78.1 dB(A)
pA
Sound power level L 91.1 dB(A)
WA
Vibration a 5.796 m/s
w

2. Proper use

The electric stapler is designed for stapling and
fastening textiles, leather and wood with the
appropriate staples and nails. The electric stapler is
designed for temporary operation. If operated
continuously, the stapler will become hot and the
increasing heat will reduce its performance. When
hot, interrupt your work and allow the stapler to cool.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

3. Safety Information

Please refer to the booklet included in delivery
for the safety instructions.
CAUTION!
For your own safety, use only staples and
nails listed in the directions for use. The use
of staples and nails other than those listed in
the directions for use may result in risk of
injury.
Be sure to pull out the power plug whenever
the tool is not being used, each time before
carrying out any maintenance, and whenever
you want to change the staples or nails!
It is important to wear suitable protective
clothing, and particularly safety goggles,
30
when working with the electric stapler/nailer.
6 mm
Please follow the safety instructions.
4. Layout (Fig. 1)
1 Trigger
1.46 kg
2 On/Off switch
II/®
3 Stapling force control
4 Magazine slide
5 Magazine
2
6 Filling level indicator
7 Stapler head
5. Starting up
Inserting the staples (Fig. 2-4)
Switch the tool off and pull the power plug.
Press the magazine slide together using your
thumb and index finger (Fig. 2).
Pull the magazine slide toward the rear of the
electric stapler (Fig. 3) and out.
Fill the magazine with staples or nails (Fig. 4).
Then slide the magazine slide back in until it
stops and snaps noticeably into place.
09.10.2006 13:20 Uhr Seite 7
GB
7