IKEA DJUPFRYSA Gebrauchsanleitung Seite 15

ENGLISH
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the Fast Freezing,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Downloaded from www.Manualslib.com
Problem
The Fast Freezing function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
The Fast Freezing function
is switched on.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
The Fast Freezing function
is switched on.
There is no cold air circula-
tion in the appliance.
manuals search engine
Possible cause Solution
Refer to "Fast Freezing func-
tion".
Refer to "Closing the door".
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off Fast Freezing man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Fast
Freezing function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
Make sure that there is cold
air circulation in the appliance.
15