Panasonic MJ-L501 Bedienungsanleitung Seite 20

Cleaning and care (Continued)
Before cleaning, detach the rubber brushes from the rotating brush,
● ■
the gasket and rubber plug from the juicing bowl.
(Rubber plug cannot be separated.)
Wash with diluted dish soap (neutral) and a soft sponge,
● ■
then rinse thoroughly with water and dry well.
• Use the tip of cleaning brush handle to clean the spouts of the juicing bowl.
(The inner surfaces may be scratched if you use the cleaning brush to clean it.)
After drying all the parts, assemble them correctly.
● ■
Do not leave them unassembled. (Otherwise there is a risk of loss,
choking on and swallowing of little parts by children, product failure, or leakage of juice.)
 ■ Rubber brushes
To detach
Push the rubber brush to the direction
indicated by the arrow mark and take the
part out from the gap.
Do not pull the rubber brush hard.
Note
Rubber brush
① ●
 ■
Gasket
Gasket is located in the centre of the juicing bowl (inner side).
●
To detach
Pull the gasket up.
 ■
Rubber plug
To detach
Pull the rubber plug out in the direction of the arrow.
Cannot be removed from the juicing bowl.
● ■
GB20
Rotating brush / Juicing bowl
Rubber brushes are located at the side of the rotating brush.
●
Gap
② ●
④ ●
③ ●
Push the gasket into opening as figure below.
Rubber plug is located on the outer bottom of the juicing bowl.
●
Push the rubber plug into the opening in the
direction of the arrow until there is no gap.
* NOT dishwasher safe
To attach
Insert the upper / lower grooves of the
rubber brush into the gap and then slide it
all the way up / down both ends.
To avoid damaging the brush, make
● ■
sure the upper and lower grooves are in
the correct position.
Gap
Upper
(Long)
Lower
(Short)
To attach
To attach
Insert the groove to
the projected part.
Top view
Sectional view