Siemens Fujitsu D2470 Kurzbeschreibung Seite 14

► Push the lever back down until it clicks into place (5).
► Depending on the configuration variant, you must pull a protective foil off the heat sink
or coat the heat sink with heat conducting paste before fitting it.
► Depending on the processor variant, clips may also be supplied for mounting
the heat sink that fix it in place.
Removing/installing the main memory
Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available on
the Internet at: "www.fujitsu-siemens.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
edition 1
Downloaded from www.Manualslib.com
Please note that, depending on the heat sink used, different heat sink
mounts are required on the mainboard.
DDR2 400 / DDR2 533 / DDR2 667 / DDR2 800 unbuffered DIMM
modules 240-pin; 1.8 V; 64 bit, no ECC
64 MB to 8 GB
64, 128, 256, 512, 1024 or 2048 MByte per module
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2 memory modules must comply with the PC2-3200U / PC2-4200U
/ PC2-5300U / PC2-6400U specification.
If you use more than one memory module, please distribute the memory
modules across both memory channels. This will enable you to exploit the
performance advantages of the dual-channel mode.
The best possible system performance can be obtained by using identical
modules in Channel A and Channel B.
To simplify equipping, the slots are colour coded. When inserting the memory modules,
start from the slot which is furthest away from the processor (slot 4).
With a memory configuration of 4 GB the visible and usable main memory may be
reduced down to 3.5 GB (depending on the system configuration).
More than 4 GB of main memory can only be used in conjunction with
a corresponding operating system.
manuals search engine
Short description of the mainboard
Channel A
Channel B
Channel A
Channel B
1
2
3
4
10