Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O P E R A T I N G I N S T R U C T I O N S
Ultrasonic Cleaner Hobbyclean
Item-No. 86 03 94
Intended Use
The vibrations caused by ultrasonic waves help loosen dust, smudges and dirt from surfaces.
You can use it to clean jewelry, eyewear, watches and consumer goods such as: razor heads,
dentures, toothbrushes, stationery, metal products, cutlery and much more. Frequency 43 KHz.
Power is supplied by connecting the device to an adequate mains socket 230 V/AC 50 Hz.
The product is only approved for use in dry indoor locations.
Any use other than that described above may damage the product and may involve other risks,
such as short-circuits, fire and electric shock. No part of the product may be changed or modi-
fied.
The safety instructions and technical data must be followed without fail!
This product complies with the applicable National and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Ultrasonic Cleaner
• Cleaning Basket
• CD Holder
• Operating Instructions
Explanation of Symbols
A lightning-bolt symbol in a triangle indicates a health hazard, e.g. danger of elect-
ric shock.
The exclamation mark in a triangle indicates a particular risk during handling, ope-
ration and control.
The „Hand" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to obser-
ve these safety instructions. Liability for any and all consequential damage
is excluded!
We do not accept liability for damage to property or personal injury caused
by improper handling or non-compliance with the safety instructions. The
warranty will be void in such cases.
• The unauthorized opening, conversion and/or modification of this product is not
permitted because of safety and approval reasons (CE).
• Power is supplied by connecting the device to an adequate mains socket 230 V/AC
50 Hz.
• The product is not a toy and must be kept out of the reach of children. Therefore,
be especially careful when children are around. Children might try to push objects
through the socket openings, for example. There is a risk of a lethal electric shock!
• The ultrasonic cleaner is not suitable for continuous use.
• The ultrasonic cleaning device may be operated only with sufficient water.
However, only fill water up to the limit „MAX".
• It is normal for the water and the objects to be cleaned to heat up during operati-
on.
• The product is suitable for use in dry indoor locations.
• Never touch the mains plug of the device with wet or damp hands. There is a risk
of a lethal electric shock!
• Do not leave packing materials unattended. They may become dangerous play-
things for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
• If the product casing is damaged, do not use the product any more! If the product
is still connected to the mains voltage, do not touch it. First switch off the mains
socket to which the product is connected (switch off the circuit breaker). Now dis-
connect the mains plug from the power socket and take the product to a speciali-
zed workshop or dispose of it in an environmentally friendly way.
• Live components may be exposed, if the covers are opened or parts removed
(unless this can be done without tools). Connection points may also be live. If the
appliance needs to be opened for calibration, servicing, repair or to replace parts
or circuit boards, it must be disconnected first from all sources of current . If servi-
cing or internal repairs are necessary, this must be carried out by a specialist who
is familiar with the risks involved and with the relevant regulations.
www.conrad.com
Version 08/10
°
Connection and Getting Started
• Place the ultrasonic cleaner on a stable, even, flat and sufficiently large surface. Do not place
the device on valuable furniture without sufficient protection, it might discolour due to chemi-
cal reactions of the rubber feet.
• Connect the device to a mains socket 230 V/AC 50 Hz.
• Open the cover and fill water up to the limit „max".
• Place the cleaning basket.
• Place the objects you want to clean in the cleaning basket.
• Close the cover.
• Press the button „POWER" on the front. The blue status LED is lit during the cleaning process.
• The ultrasonic cleaner switches off automatically after 3 minutes.
• Check whether the objects have been adequately cleaned. If not, repeat the cleaning process.
• Pull the mains plug from the mains socket if the device will not be used for a long period of
time.
Maintenance and Cleaning
Always disconnect the ultrasonic cleaner from the mains before cleaning it.
Use a clean, lint-free, dry and anti-static cloth to clean the housing. Do not use abrasive or che-
mical agents, or cleaners containing solvents.
Disposal
Technical Data
Operating voltage:
Capacity:
Input:
Cleaning time:
Casing:
Cleaning basket:
Colour:
Weight:
Dimensions:
© Copyright 2010 by Conrad Electronic SE.
• A safe operation can no longer be assumed, if:
- the device is visibly damaged,
- the device no longer functions and
- if the device was stored under unfavourable conditions for a long period of time
or
- if it was exposed to extraordinary stress caused by transport
• In commercial institutions, the accident prevention regulations of the Employer's
Liability Insurance Association for Electrical Systems and Operating Materials are
to be observed.
• In schools, educational centres, hobby and self-help workshops the operation of
the product is to be supervised by trained employees.
When filling the device with fresh water, consider a degassing time, depending on
the hardness (you can obtain the best cleaning effect by using degassed water,
e.g. boiled or distilled water). In other cases, we recommend to fill the device with
water and let it run for several minutes before placing the objects, so that the water
can be degassed.
Electrical and electronic products do not belong in the household waste!
Please dispose of the device, when it is no longer of use, according to the cur-
rent statutory requirements.
230 V/AC 50 Hz
600 ml
50 watts
3 minutes
ABS
Stainless steel
white
approx. 850 grams
approx. 206 x 175 x 147 mm
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
Werbung
