Attaching The Ceiling Mount To The Ceiling - Sharp AN-SV100T Bedienungsanleitung

Attaching the Ceiling Mount to the Ceiling

When installed with the AN-TK201
Attach the ceiling mount to the ceiling.
• First, lightly screw an installation bolt into the smallest hole
for the holes
• Use M8-type bolts. (Bolt type may vary depending on the method of installation.)
• Use the washers supplied with the ceiling mount.
• Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility
whatsoever if inadequate installation causes your projector or attached devices to fall out of
place.
12
Downloaded from www.Manualslib.com
Mounting bolt (M8-type)
, and . Once the position has been decided, fi rmly tighten all four bolts.
Caution
manuals search engine
Washer
and then proceed, doing the same