Technical Data - EINHELL BT-SW 800 Bedienungsanleitung

Anleitung BT-SW 800_SPK1:_
1. Scope of use
The mechanical sweeper is intended for sweeping
level and dry areas such as entrance drives, ter-
races, yards, etc.
2. Safety information
Suitable measures must be taken to keep the
unit out of the reach of children.
Immediately replace defective parts.
Use only original replacement parts.
We will not be liable for any damage that results
from improper repairs and/or improper handling
of the unit (e.g. using the unit in ways for which it
was not intended).
The sweeping up of gel-like, liquid, combustible
or explosive substances is not permitted.
Do not use the mechanical sweeper to sweep up
glowing or harmful objects.
3. Layout and items supplied (Fig. 1)
1. Push bar
2. Fastening nuts for push bar
3. Debris collector
4. Setting screws for adjusting the height of the rear
pick-up brush
5. Setting screws for adjusting the height of the
rotor brushes
6. Rotor brushes
4. Assembly
see Figure 2-5
When mounting the front cleaning brushes, make
sure that the two locking lugs engage on the
mechanical sweeper.

5. Technical data

Working width
Debris collector
Sweeping capacity (at 3-4 km/h) approx. 2800 m
Size 1230 x 850 x 980 mm
Weight
22.06.2007 10:11 Uhr
6. Operation
When the mechanical sweeper is pushed, the feed-in
brushes (Fig. 6/B) and the pick-up brushes (Fig.
6/C) are set in rotation by the belt drives (Fig. 6/A).
The rotating feed-in brushes (Fig. 6/B) sweep the
dirt to the center. The two counter-rotating pick-up
brushes (Fig. 6/C) convey the dirt into the debris col-
lector (Fig. 1/3).
7. Adjusting the feed-in brushes and
the pick-up brushes (Fig. 7)
The feed-in brushes and the rear brush can be
adjusted to 4 different heights as required.
8. Emptying the debris collector (Fig. 8)
After sweeping up metal, glass or sharp objects,
wear heavy-duty work gloves when emptying the
debris collector.
9. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
80 cm
37 l
2 /h
11 kg
Seite 7
GB
7