Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Downloaded from
www.Manualslib.com
Switch Operation
1. Depress the trigger switch slightly to start the tool slowly.
2. The speed increases with the amount of depression of the trigger for effi-
Reversing Switch Operation
(Forward ( ), Switch Lock, Reverse ( ))
CAUTION!
Do not operate reversing lever until the chuck comes to a complete stop. Shif-
ting during rotation of the chuck may damage the tool.
1. For reverse rotation, set the lever to reverse. Check the direction of ro-
2. After use, set the lever to its center position (switch lock). (Fig. 6)
Speed Selection
Choose a low or high speed to suit the job.
CAUTION: Check the speed selector switch before use.
Clutch Torque Setting
Adjust the torque to one of the 18 possible settings or " " position to the job.
CAUTION! Test the setting before actual operation. (Fig. 7)
Note:
When the brake operates, a braking sound may be heard. This sound indica-
tes engagement of the bit lock.
CAUTION:
●
●
●
●
●
For Appropriate use of Battery pack
NI-MH Battery Pack
●
Charge the Ni-MH battery fully before storage in order to ensure a longer
service life.
●
The ambient temperature range is between 0°C and 40°C.
If the battery pack is used when the battery temperature is below 0 °C, the
tool may fail to function properly. In that case, charge the battery until char-
ging is completed for appropriate functioning of the battery.
Battery Pack Life
The rechargeable batteries have a limited life. If operation time becomes ex-
tremely short after recharging, replace the battery pack with a new one.
Note:
●
Use under extremely hot or cold conditions will reduce operating capacity
per charge.
●
Battery pack contain Nickel-Cadmium batteries.
The batteries must be recycled or disposed of properly.
manuals search engine
cient tightening of screws and drilling. The brake operates and the chuck
stops immediately when the trigger is released.
tation before use.
To eliminate excessive temperature increase of the tool surface, do not
operate the tool continuously using two or more battery packs. Tool needs
cool off time before switching to another pack.
Do not close up vent holes on body sides of the body during operation.
Otherwise, the machine function is adversely affected to cause a failure.
Do NOT strain the tool (motor). This may cause damage to the unit.
Use the machine in such a way as to prevent the air from the body vent
holes from blowing directly or to your skin. Otherwise, you may get burnt.
When operating with a Ni-MH battery pack, make sure the place is well-
ventilated.
11
Werbung
