Connectors; Connecting Other Equipment - Medion 40518 disney classic tv Bedienungsanleitung

Fitting the loudspeakers ("ears")
For sound output, the loudspeakers must be fitted.
• Fit the loudspeaker marked "R" (right) to the right
side of the TV set. The underside of the loudspea-
ker must be flush with the TV set.
• Fit the other loudspeaker marked "L" (left) to the
left side of the TV set.

Connectors

Antenna connector
To connect to the house antenna or cable system, connect a double-screened cable from the
antenna socket to the television set.
Headphone connection
On the front of the set is a headphone socket, suitable for any normal headphones fitted with
a 3.5-mm jack plug. When headphones are in use, the loudspeakers are turned off.
CAUTION!
Too high a volume, especially when using headphones, can damage your hearing. For
this reason, you should turn the volume right down before connecting the headpho-
nes.
Power connection
Do not connect the appliance to the mains until you have made all the other connections. Insert
the device's plug into a mains socket (230 V ~ 50 Hz) that is close to the place where you
have set the up the device.

Connecting other equipment

The SCART socket on the rear and the Audio/Video outputs on the front panel can be used
to connect various audio and video appliances (video-recorders, SAT receivers etc.).
To connect an external appliance, connect it
• either with a SCART cable (SCART socket on rear of TV)
• or with audio Cinch cables (AV connectors on front panel of TV).
Please note the instructions regarding additional equipment in the operating instructions.
GB-9