Makita DTM40 Bedienungsanleitung Seite 5

Vibration
The vibration
determined according to EN60745:
Work mode: Sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: Cutting with plunge cut saw blade
Model DTM40
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTM50
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: Cutting with segmental saw blade
Model DTM40
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTM50
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode: Scraping
Model DTM40
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTM50
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Downloaded from www.Manualslib.com
total value (tri-axial vector
2
) : 2.5 m/s or less
h
2
2
) : 9.5 m/s
h
2
2
) : 10.0 m/s
h
2
2
) : 5.0 m/s
h
2
2
) : 5.5 m/s
h
2
2
) : 7.5 m/s
h
2
2
) : 9.5 m/s
h
2
manuals search engine
ENG900-1
For European countries only
sum)
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Cordless Multi Tool
Model No./ Type: DTM40, DTM50
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
000331
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
CORDLESS MULTI TOOL
SAFETY WARNINGS
ENG901-1
1. This power tool is intended to function for
sawing, cutting, grinding and sanding. Read
all safety warnings, instructions, illustrations
and specifications provided with this power
tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious
injury.
2. Hold power
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring. Cutting accessory contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5
ENH101-18
31.12.2013
Yasushi Fukaya
Director
tool by insulated gripping
GEA010-1
GEB094-2