Fitting/changing the saw blade
CAUTION!
►
If the saw blade
replaced immediately .
►
When changing the saw blade
compressed-air supply is disconnected!
♦
First open the cover
♦
Then use the enclosed 4 mm hex key
socket screws
saw blade
♦
Then set the new saw blade
and tighten the hexagon socket screws
holder
firmly .
♦
Make sure that the saw blade
blade holder
♦
Then close the cover
Adjusting/changing the stop bracket
♦
Loosen the hexagon socket screw
the enclosed 2 mm hex key
After loosening the hexagon socket screw
can be removed by pulling .
♦
Now an adjustment or a complete exchange of the stop
bracket
is possible .
♦
After changing or adjusting the stop bracket
previously loosened hexagon socket screw
hex key
.
■
18
│
GB │ CY
is blunt, bent or defective, it must be
using a Phillips screwdriver .
for the saw blade holder
.
and can no longer be pulled out .
again using the Phillips screwdriver .
, always make sure that the
to loosen the hexagon
and remove the
into the saw blade holder
for the saw blade
is correctly fitted in the saw
for the stop bracket using
.
the stop bracket
, retighten the
using the 2 mm
PDKS 6.3 B3