The Worklight; Operating The Inflator - Westfalia ALV18 Originalanleitung

 Do not leave batteries on charge for extended periods and never
store batteries on charge.
 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.

The Worklight

The worklight (4) automatically turns on while the inflator is operated. It
turns off a few seconds after the inflator is turned off.
Operating the Air Inflator
Use one of the included adapters to connect the inflator to the object to
be inflated. The pump sucks in air through the port on the top and
blows it out through the nozzle at the front. To inflate objects, attach the
adapters to the nozzle and secure the large adapter with the bayonet
coupler (figure A, page III). Connect the adapter with the air valve of the
object to be filled and press the trigger switch (5) to turn on the inflator.
To quickly and fully deflate inflated objects insert the adapters to the
port on top (figure B, page III). When you turn on the inflator by
pressing the trigger switch (5) the air is sucked out of the item.
Operation
17