Eliminating Minor Faults Yourself - Bosch GSN Serie Gebrauchsanleitung

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Freezer compartment
temperature display flashes.
Fig. "/1
Warning signal sounds.
The alarm button is lit.
Fig. "/3
The freezer compartment is
too warm!
Frozen food is at risk!
Freezer compartment
temperature display flashes.
Fig. "/1
Alarm button flashes.
Fig. "/7
36
Possible cause
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed
in the freezer compartment
at once.
A fault caused the freezer
compartment to become too
warm in the past.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether the power
is on, check the fuses.
To switch off the warning signal, press
the "alarm" button, Fig. "/7.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been eliminated, the alarm
display goes out shortly afterwards.
When the alarm button 7 is pressed, the
temperature display stops flashing. Fig. "/1
The temperature display indicates for 5
seconds the warmest temperature which was
reached in the freezer compartment.