Setting The Time - Hama 137289 Bedienungsanleitung

(euro/kWh)
Note
• If the energy cost meter cannot be started, then
press the reset button (5) for a few seconds.
• The rechargeable battery is charged during
operation.
• The internal rechargeable battery will discharge
if the timer switch is not used for longer periods
of time. Plug the energy cost meter into a mains
plug for approx. 24 hours every 3 months to
charge the internal rechargeable battery.
Press the FUNC button to view the following displays
in succession:
• VOLTac: mains voltage, mains frequency and time
are displayed
• AMP: current, power factor and time are displayed
• WATT: output, power factor and time are displayed
• WATT max: maximum output is displayed
• kWh: kWh consumed, power factor and time are
displayed
• TOTAL PRICE; TOTAL ON TIME: total price and usage
duration are displayed
• PRICE1: Price 1 is displayed
• PRICE2: Price 2 is displayed

5.1 Setting the time

• Press the FUNC button until CLOCK is shown in
the display.
• Press the SET button and use the UP button to set
the day of the week.
• Press the SET button and use the UP button to
set the hour.
• Press the SET button and use the UP button to set
the minutes.
• Press the SET button to save your settings.
• Press the UP button to choose between 12-h and
24-h mode.
5.2 Setting price
• Press and hold the FUNC button for a few seconds
until COST/Kwh is shown in the display.
• Press the SET button to set Price 1. Use the SET
button to select the digit you would like to enter.
• Enter the required value using the UP button.
• Press the SET button and use the UP button to set
the corresponding days of the week.
• Press the SET button and use the UP button to set
the corresponding time.
• Press the SET button to save your settings.
• After setting Price 1, press the FUNC button to set
Price 2. Then repeat the steps described above.
• After setting Price 2, press the FUNC button to set
the maximum overload value.
• Press the SET button and then select the digit you
would like to enter.
• Enter the required value using the UP button.
• Press the SET button to save your setting.
• Press and hold the FUNC button for a few seconds
to return to the standard display.
6. Measurement
Note
• Precise measurement results even for small
appliances.
• The voltage and power draw of the connected
devices may not exceed 230 V and 3680 W.
• Note the information specified on the name-
plate(s) of the connected device(s).
• If you connect an electrical appliance that draws
more than 3680 W, then the display shows
OVERLOAD.
• It is advisable to measure the power consump-
tion of a device for an extended period of time
and then calculate its annual consumption.
• Plug the energy cost meter into a conventional
mains socket.
• Plug the electrical device to be measured or its
mains plug into the socket on the energy cost
meter. The consumption measurement commences
automatically.
• Press the FUNC button to change the display mode.
• Unplug the electrical device from the energy cost
meter or the energy cost meter from the mains
socket to end the measurement.
4