Vr-Kühlkörper; Removing The Vr Heat Sink; Installing The Vr Heat Sink - Dell OptiPlex 5080 Tower Serviceanleitung

3. Bringen Sie die Seitenabdeckung
4. Folgen Sie den Anweisungen unter
VR-Kühlkörper

Removing the VR heat sink

Prerequisites
1. Follow the procedure in
WARNING: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool
before you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in
your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the VR heat sink and provides a visual representation of the removal procedure.
Steps
1. Loosen the two captive screws that secure the VR heat sink to the system board.
2. Lift the VR heat sink off the system board.

Installing the VR heat sink

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the VR heat sink and provides a visual representation of the installation procedure.
an.
Nach der Arbeit an Komponenten im Inneren des
before working inside your computer.
Computers.
Ausbau und Wiedereinbau 49