Installing The Application Programme - Panasonic AW-SW350E Handbuch

6
In order to confirm that the device driver has been installed successfully, it is
recommended that you open the Device manager as shown in Fig.5, and check that
"AW-SW USB Device:AW-SW350" is displayed.
Fig.5 Device manager screen
24 (E)

INSTALLING THE APPLICATION PROGRAMME

This section describes how to install the application programme used with the USB image
transfer programme for the AW-SW350. In the example of the procedure given below,
Windows XP is used as the operating system.
1
Insert the CD-ROM supplied with the AW-SW350 in the CD-ROM drive of the host
computer. (In this example, E: is the drive used.)
2
Run the "Microsoft .Net Framework" setup file (E:\JPN\DOTNETFX.EXE).
3
The installer programme shown in Fig.6 now starts. Proceed with the installation by
following the installer instructions.
Fig.6 Microsoft .Net Framework installer start screen
4
Run the setup programme (E:\JPN\SETUP.EXE).
25 (E)