Final Assembly - Philips LTC 9405 Serie Installationsanleitung

Figure 6: Installing the Mount System
Figure 7: Securing the Mount System with Alternate Bracket
3. Secure the camera to the mount using the ¼-20 x ½ inch
button-head flange screw provided in the hardware kit. See
figures 8, 9 and 10.
Figure 8: Camera Mounts
Figure 9: Camera and Mount System
Figure 10: Camera Mounted with Alternate Bracket to a
5.4

Final Assembly

1. Mount the cover by aligning the two studs near the rear of
the cover with the openings of the z-shaped slots in the top
panel. Slide the cover to the rear, then upward and finally
to the rear again. Tighten tamper-resistant screw or lock
with key. See figure 11.
Figure 11: Installing the Cover
1.7
Wall