Kärcher 2.643-381.0 KM Medium Bedienungsanleitung Seite 11

3.3 Producing the recess for the holder
Figure 2: Recess on the left cover
3.4 Drawing in the cable harness
Figure 3: drawn-in cable harness
3.5 Connecting the cable harness to the circuit board
Figure 4: The photo shows the plug of the cable harness
already connected to the circuit board of the control unit.
ATTENTION
Risk of damage!
Mind internal cables.

Open left cover.

Mark the recess and the holes to be drilled by means of

the provided template.
Mark the recess and the holes to be drilled by means of

the provided template.
Produce recess.

Drill 4 holes using a ø 3.5 mm drill.

Note
The holder with the fleet management module will be in-
serted and secured in the prepared recess later on.
1 Cable conduit
2 Cable harness with 24-pin plug end
Pull the cable harness through the produced recess

along the already installed cable conduit towards the
top (using a wire).
1 Plug (X1A1)
2 Plug casing (XA11.1)
3 Plug (XA11)
4 Plug (X301)
5 Plug (X200)
Plug the plugs of the cable harness into the circuit

board in accordance with the illustration and the follow-
ing description.
3
-
EN 11