Moving The Stand And Display; Preventing Equipment From Falling Over - Pioneer PDK-FS05 Bedienungsanleitung

Installation and assembly instructions
10
Attach one support column cover to the center
support column to cover cables, and fix it with
screws (M4 x 7 mm: silver) (2 screws, on the top
and bottom).
Support
column cover
Be careful not to allow cables to become caught in
the support column covers.
Caution
11
Follow the same procedure to attach the support
column cover on the other side, and fix it with
screws (M4 x 7 mm: silver) (2 screws, on the top
and bottom).
12
Attach cap.
13
Attach cable clamps.
The cable clamps may be used to bundle up any excess
lengths of cable as shown in the diagram below.
Note
Be careful not to step on any cables when moving the stand.
14
En
Pull the support
column cover toward
you slightly, then
bend it around
toward the back.
The side with the cutout
portion is the rear side.
Cap
Cable clamp

Moving the stand and display

When moving the stand and display, hold the stand by its
center support column.
When moving the stand and display, never do so by
holding the plasma display, speakers, or glass panel, as
doing so might result in breakage or damage to the
equipment.
When moving over an uneven surface of any kind, pick up
the stand and display by the base of the stand.
Be careful when you place the stand and display on a thick
carpeted surface, because when you do, the fibers may
become entwined in the casters preventing them from
rolling.
When moving the stand and display.
Depending on the type of surface on which the stand is
placed, the casters may leave marks on the surface, and
this should be taken into consideration when selecting the
place in which the stand is to be placed.

Preventing equipment from falling over

After installing the stand, be sure to take special
care to ensure that the Plasma Display will not fall
over.
1
Attaching falling prevention bolts to the Plasma
Display.
2
Using strong cords or chains to stabilize it
appropriately and firmly to a wall, pillar, or other
sturdy element.
Perform this work in the same way on the left and right sides.
Note
Use falling prevention bolts, ropes, chains,
and fittings that are available on the
market.
Recommended hook:
Nominal diameter M8
Length 12 to 15 mm
12 to 15 mm
1
Falling prevention
bolts
Fitting
2
Cord or chain