Daily Use - Electrolux EQT4520BOG Benutzerinformation

68 www.electrolux.com

DAILY USE

ON AND OFF
Touch
appliance.
AUTOMATIC SWITCH OFF
The function deactivates the appliance
automatically if:
• All roasting zones are deactivated
• You do not set the temperature after you
activate the appliance.
• You spill something or put something on
the control panel for more than 10 sec-
onds, (a pan, a cloth, etc.). The sound
operates some time and the appliance
deactivates. Remove the object or clean
the control panel.
• You do not deactivate a roasting zone or
change the temperature. After 90 mi-
nutes
deactivates. Before next use, set the
roasting zone to
THE HEAT SETTING
Touch the control bar at the heat setting.
Change to the left or the right, if it is neces-
sary. Do not release before you have a cor-
rect heat setting. The display shows the
heat setting.
If you set the temperature, the display
flashes until the roasting zone reaches the
temperature. Then a signal sounds and the
display shows the temperature.
BRIDGE FUNCTION
The Bridge function connects two roasting
zones to have them operate as one.
First set the heat setting for one of the
roasting zones.
for 1 second to start or stop the
comes on and the appliance
.
To activate the Bridge function, touch
To set or change the heat setting, touch
one of the control sensors.
To deactivate the Bridge function, touch
. The cooking zones operate independent-
ly.
THE TIMER
.
The Count Down Timer.
Use the Count Down Timer to set how long
the roasting zone operates for only this one
time.
Set the Count Down Timer after the se-
lection of the roasting zone.
The selection of Timer function is
possible for roasting zones that are
active and the heat setting is set.
• To set the roasting zone: touch
again and again until the indicator of a
necessary roasting zone comes on.
When this function is activated,
comes on.
• To activate the Count Down Timer:
touch of the timer to set the time (
00 99
- minutes). When the indicator
of the roasting zone starts to flash slow,
the time counts down.
• To see the remaining time: set the
roasting zone with
the roasting zone starts to flash quickly.
The display shows the remaining time.
• To change the Count Down Timer:
set the roasting zone with
or .
• To deactivate the Count Down Tim-
er: set the roasting zone with
. The remaining time counts back to
00
. The indicator of the roasting zone
goes out.
When the timer countdown comes to an
end, the sound operates and
The roasting zone deactivates.
• To deactivate the sound: touch
.
. The indicator of
touch
. Touch
00
flashes.