Blaupunkt CV 250 Bedienungsanleitung Seite 12

[12] Teletext Hold :
Allows to congeal the current teletexte page on screen.
[13] Mute : allows you , depending on the mode, to turn on/off the sound
[15] A.B
Selection of Audio / Video equipment : identical function as in the original remote.
[16] numeric keys 0 - 9 :
Work the same way as in your original remote
[17] TV, VCR, SAT button :
These keys allow you to select the equipment you want to control.
[18] Power :
Allows you to switch on and off the choosen equipment
[19] :
Allows you to control the lamps and appliances connected to X-10 home automation
modules.
Programming your TV, VCR and satellite receiver
1. Make sure your equipment is switched on (for example TV)
2. Press and hold the S key until the LED indicator lights continuously. Release the S key.
3. Press and release the mode key of the device you want to control (for
3. Enter the 3 digit code from the library table . The LED turns off after the last digit is entered.
If you entered a wrong code the LED blinks for 3 seconds and then goes off. You have to
repeat from step 2.
5. Point the remote in the direction of your TV and press the POWER button. Your device should
turn off . Check other functions (for example for a VCR : FF or REW etc.). If certain functions
are not responding this indicates that the entered code is not the correct one. In that case
repeat the above procedure with the next corresponding code of your brand.
6. Repeat this procedure for the other equipment you want to control ( TV, VCR or SAT)
Automatique code search « AUTOSEARCH »
If your equipment (TV, SAT etc....) does not respond, try the other codes for your brand . If it
still doesn't respond, try the Code Search method.
example TV).