AEG rc 4000 Bedienungsanleitung Seite 44

English
46
2. Press and hold the respective selection
key (e.g. ) until the LED extinguishes
briefl y.
3. Activate the search function by
pressing the " " key (18). The LED
will start to fl ash.
4. As soon as the device responds (e.g.
switches off ), confi rm by pressing the
selection key again (e.g.
will fl ash 4 times slowly.
Note:
• Confi rmation of the device code must
take place within one second.
• The search mode can be ended at
any time by pressing the EXIT key (8).
The LED also fl ashes 4 times rapidly;
the previously programmed code is
retained.
5. Check the function of the keys on the
device. If several of the keys do not
function or incorrectly, repeat the
search.
If this method proves unsuccessful,
use the Learn function to program the
remote control as described below.
Note:
Owing to the numerous diff erent brands
on the market, complete programming of
all the functions of your original remote
control cannot be guaranteed.
Learn function
The universal remote control is able to
"learn" the individual key functions of
your original remote control. This function
can be used, e.g. when not all functions
are programmed via the "Code Search"
function.
Note:
Do not use the following keys for the
Learn function: Light (3), Record (10),
EXIT (8) and Selection keys (1).
1. Ensure that your original remote control
works perfectly.
2. Place both remote controls on a fl at
surface and point both ends that are
normally aimed at the device towards
each other. The distance between both
remote controls should be 2 - 5 cm.
3. Press and hold the respective selection
key (e.g.
briefl y.
4. Press the "
5. Now press the key on the universal
remote control to be programmed.
6. Press and hold the respective key on the
original remote control until the LED
fl ashes 4 times slowly. The programmed
). The LED key function is automatically stored.
Note:
• If programming is unsuccessful, the
LED will fl ash 4 times rapidly.
• Neon light can infl uence
programming.
7. Repeat steps 5 and 6 until all key
functions on the universal remote
control have been programmed.
8. Finally press the EXIT key to leave the
programming mode. The LED will fl ash
4 times rapidly.
Delete programming
There is a possibility to delete individual
keys or all keys of a device.
Note:
Programming can only be deleted that
was carried out via the Learn function.
Delete individual keys
1. Press and hold the selection key for the
respective device (e.g.
extinguishes briefl y. Subsequently press
the EXIT key (8).
2. Now press the key to be deleted. The
LED will fl ash 4 times slowly.
3. Press the next key to be deleted.
4. When all required keys have been de
leted, press the
vice
The LED will fl ash 4 times rapidly.
Delete all keys of a device
1. Press and hold the "
the LED extinguishes briefl y.
2. Press and hold the selection key of the
device, the keys of which are to be
deleted (e.g.
3. The LED will fl ash 4 times slowly. All
keys stored under this selection key are
deleted.
) until the LED extinguishes
" key (10).
) until the LED
selection key of the de
to leave the delete mode
" key (10) until
).
-
-
(e.g. ) .