Assembly; Joining The Stand And The Control Unit - Sony BKM-38H Handbuch

Left stand (1)
Right cover (1)
Left cover (1)
Joints (2)
Legs (2)
Screws A (3 × 8) (8)
Screws B (4 × 8) (6)
Screws C (4 × 16) (4)
Screws D (4 × 16) (2)
(without flat washer)
Connecting cable (1)
12

Assembly

Assembly
Joining the Stand and the Control
Unit
You can join a control unit to a monitor, using the
attachment stand.
1
1 Fit the control unit into the projection of the
attachment stand to join them together.
2 Attach the left and right stands to the sides of the
control unit, using two screws C (4 × 16) each.
Left stand
2
Connect the supplied connecting cable to the DC 12V
and LAN (10/100) connectors on the rear panel of the
control unit.
Note
Plug the connector of the DC cable (L-shaped) to the
DC 12V connector.
Right stand
Screw C