Inhaltsverzeichnis
Werbung
Assembly Instructions
has to be equipped with the correct cutting disc before mounting. The cutting
disc can not be changed while the angle grinder is attached to the stand. Now
check whether your angle grinder is equipped with a 10, 8 or 6 mm treated
mounting hole for the accessory handle. Find the correct retaining screws (8)
and the corresponding nuts (9). (Please follow figure B).
Fig. B
Stick the correct retaining screws (8) through the mounting pieces (14).
Because most angle grinders require 8 mm screws, the correct plastic inserts
for 8 mm screws are already installed. If you require a different size of screw,
remove the plastic insert and use the smaller insert for the smaller 6 mm
screws or no insert for 10 mm screws. Mount the mounting pieces (14) by
clamping them with the nuts (9).
Insert the adjusting screw (13) into the lower hole and the adjusting screw (7)
into the upper hole of the retainer (6). The rubber buffers of the screws must
rest on the housing of the angle grinder after mounting (See figures A and D).
Initially, retract the rubber buffer against the retainer (6).
11
Werbung
Inhaltsverzeichnis
