Safety Instructions For Maintenance; Assembly - Husqvarna DS150 Bedienungsanweisung

• Always use approved hearing protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
• The product makes dust and fumes that contain
dangerous chemicals. Use an approved breathing
protection.
• Use boots with steel toe-caps and non-slip soles.
• Make sure that you have a first aid kit near.
• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
To do a check of the carriage lock
1. Turn the knob to lock the drill motor carriage.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To install the wheel kit
The wheel kit is not supplied for all models.
1341 - 002 - 24.10.2019
2. Feel by hand that the drill motor carriage is locked to
the drill column.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product. Save
all warnings and instructions for future
operations.
• Stop the drill motor, disconnect the power supply
and remove the drill motor before maintenance of
the product.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved servicing dealer.
• Do the maintenance to make sure that the product
operates correctly. Refer to
page 10 .

Assembly

• Attach the wheel kit to the bracket at the rear end of
the bottom plate and tighten the screws.
Daily maintenance on
5