Troubleshooting - Canon K30274 Benutzerhandbuch

Troubleshooting

If any trouble occurs during use of the battery, determine its cause and take
an appropriate remedial action as explained below.
Battery is Connected but Printer Does Not Operate
An attempt is made to print data after connecting the battery to the printer,
but the printer does not operate.
• Is the battery connected securely?
Check that the battery is securely connected to the printer.
• Is the charge level of the battery pack OK?
Check the charge lamp on the battery attachment. If the charge lamp
flashes green quickly, the charge level of the battery pack is low.
Charge the battery pack.
For the charge lamp indication, see below.
Charge Lamp is Lit or Flashing
Charge lamp
The lamp stays green.
The lamp flashes green slowly.
The lamp flashes green quickly.
Charge level/Action
Fully charged.
Charge remaining.
Charging is required.
See "Charging the Battery"
(The printer status monitor displays a message
prompting you to charge the battery.)
Charge lamp
The lamp flashes red and green
alternately.
For details on the printer status monitor, refer to the manual of the printer.
Note
The battery condition is indicated when the battery is used under the
following situations:
• The battery is connected to the printer.
• The printer is operating from the battery.
Be sure to turn off the printer before connecting or disconnecting the AC
adapter. The battery charge level indication may become incorrect if you
connect or disconnect the AC adapter with the printer on.
Specifications (Battery Pack)
Type Lithium-ion
Nominal voltage DC11.1 V
Nominal capacity 2.3 Ah
Charge time Approx. 3 hours
External dimensions Approx. 161 (W) × 41 (D) × 27 (H) mm
(Width x Depth x Height) Approx. 6.4 (W) × 1.7 (D) × 1.1 (H) inches
Weight Approx. 180 g (6.3 oz.)
Specifications are subject to change without notice.
Charge level/Action
The battery pack may be faulty.
Turn off the printer, and disconnect the AC
adapter and the battery from the printer. After
that reconnect them and turn on the printer.
If the same error occurs, contact your Canon
service representative.
The charge lamp flashes only when the AC
adapter is connected to the printer.
8