Specifications - Makita AF550H Bedienungsanleitung

ENGLISH (Original instructions)
3-1. Locking position
3-2. Released position
3-3. Lock lever
4-1. Trigger
4-2. Contact element
5-1. Trigger
5-2. Contact element
8-1. Adjuster
9-1. Too deep
9-2. Flush
9-3. Too shallow
11-1. Lever
11-2. Sliding door

SPECIFICATIONS

Pneumatic tool oil
Dimensions (L X H X W)
Min. hose diameter
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fastening on interior work and
furniture work.
Noise
The typical A-weighted
according to EN792:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Explanation of general view
12-1. Magazine
12-2. Nail
12-3. Groove for the sliding door
12-4. Grooves at the bottom of the
magazine
13-1. Nail discharge opening
13-2. Nails
13-3. Magazine
14-1. Front driver guide
14-2. Nose adapter
14-3. Protrusion
15-1. Holder
15-2. Nose adapter
Model
Air pressure
Nail Iength
Nail capacity
Net weight
noise level determined
) : 74 dB(A)
pA
END106-3
Vibration
The vibration total value determined according to
EN792:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE073-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
17-1. Trigger
17-2. Lock lever
17-3. Contact element
18-1. Place first the contact element
against workpiece.
19-1. Holder
19-2. Hex wrench
20-1. Rear driver guide
20-2. Screws
20-3. Front driver guide
24-1. Cap
27-1. Drain cock
AF550H
0.98 - 2.26 MPa (9.8 - 22.6 bar)
15 mm - 55 mm
100 pcs.
ISO VG32 or equivalent
228 mm X 61 mm X 235 mm
5.0 mm or more
1.3 kg
) : 2.5 m/s
h
2
ENG904-2
2
or less
ENG901-1