Fitting The Hob Into A Worktop; Making An Electrical Connection - Sharp KH-6I27CS00-EU Bedienungsanleitung

exceed 2 metres.
Fitting the hob into a work
surface
· The hob can be inserted into any
worktop provided it is heat resistant up
to at least 90ºC.
· Create an opening with the
dimensions shown in the picture below
and on the next page.
· The induction hob may be built in 25
to 40 mm thick worktops.
· Apply one-sided self-adhesive sealing
tape supplied all the way round the
lower glass edge of the cooking sur-
face along the outer edge of the glass
ceramic panel. Do not stretch it.
· Screw the 4 worktop mounting brac-
kets on the side walls of the product.
Making an electrical connecti-
on
Before making a connection, check
that:
The voltage power supply is the same
as that quoted on the rating plate
which is situated at the back of your
hob.
The circuit can support the appliance
load (see the rating plate).
3x2,5 mm² 220V~
3x2,5 mm² 230V~
3x2,5 mm² 240V~
3x2,5 mm² 220V~
3x2,5 mm² 230V~
3x2,5 mm² 240V~
The power supply has a grounded
connection connection, which complies
with the provisions of current regulati-
ons and is in good working order.
The fused switch is easily accessible
once the hob has been installed.
If there is no dedicated hob circuit
and fused switch, they must be instal-
EN- 16
5x1.5 mm² 380V 3N~
5x1.5 mm² 400V 3N~
5x1.5 mm² 415V 3N~
/
5x1.5 mm² 380V 3N~
5x1.5 mm² 400V 3N~
5x1.5 mm² 415V 3N~