Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.2 Bicycle light
After installing the bracket, you can simply slide the bicycle light onto the
bracket. You should be able to hear it click into place. To remove the bicycle
light, press down the lever (4) and pull out the bicycle light.
4.3 Getting Started and Operation
To switch it on, briefly press the button (2) two times. To switch it off, hold
down the button (2) for about 1 second.
Press once for eco mode and again for high power mode.
4.4 Replacing the Batteries (Pic. 3)
As soon as the battery indicator lamp (1) turns red, you have to change the
batteries immediately. This is the only way to continue ensuring safe use of
the product on the road.
To change the battery, first remove the bicycle light from the bracket so you
can open the battery compartment. Then pull out the battery compartment
(3) and put in new batteries (3 micro/AAA). Make sure that the polarity is
correct.
Then put the battery compartment back in the bicycle light.
5. Installation/Removal rear light
5.1 Getting Started and Operation (Pic. 4)
Two inserts are included for a perfect grip on the seatpost. The "L" insert is
for diameters from 32 to 42 mm and the "S" insert is for diameters from 25
to 32 mm.
To switch it on and off, briefly press the button (2) two times.
5.2 Replacing the Batteries (Pic. 5)
As soon as the battery indicator lamp (1) turns red, you have to change the
batteries immediately. This is the only way to continue ensuring safe use of
the product on the road.
For this purpose, pull off the "S" or "L" insert and use a coin to unscrew the
battery compartment below it in a clockwise direction. Remove the battery
cover and put in new batteries (2x CR2032). Make sure that the polarity is
correct.
Then put the battery cover (3) back on and tighten it in an anti-clockwise
direction. Now put the appropriate insert back in.
6. Technical Specifications
6.1 Front light
Maximum light
output
Maximum operating
time
Lighting range
Splash protection
Operating voltage
(Tested with 3 AAA alkaline batteries according to StVZO 22A, TA23)
Eco
High Power
60 lm
100 lm
2 hr. and
1 hr. and
20 min.
40 min.
92 m
92 m
IPX4
IPX4
4.5 V
4.5 V
(3x1.5 V AAA)
(3x1.5 V AAA)
6.2 Rear light
Maximum operating time
Splash protection
Operating voltage
(Tested with 2x CR2032 batteries according to StVZO 22A, TA14
(III))
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use
aggressive cleaning agents.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of the
product or from failure to observe the operating instructions and/or safety
notes.
9. Recycling Information
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU
and 2006/66/EU in the national legal system, the following
applies: Electric and electronic devices as well as batteries must
not be disposed of with household waste. Consumers are obliged
by law to return electrical and electronic devices as well as batteries at the
end of their service lives to the public collecting points set up for this purpose
or point of sale. Details to this are defined by the national law of the
respective country. This symbol on the product, the instruction manual or the
package indicates that a product is subject to these regulations. By recycling,
reusing the materials or other forms of utilising old devices/Batteries, you are
making an important contribution to protecting our environment.
20 hr.
IPX4
6 V (2x 3 V CR2032)
Werbung
