Completing The Installation - HP LTO Ultrium 6650 Kurzanleitung

Powering on the server
Power on the server.
If the BIOS for the controller in your server displays
connected devices, watch the server boot screen
to verify that the new SAS tape drive is listed in the
boot sequence.
If you see any error or unexpected messages, verify
that the SAS cables are connected correctly. If this
does not resolve the problem, see the user guide
for further troubleshooting information.
The tape drive runs a hardware self-test, which
takes up to 21 seconds.
If the self-test passes, the green Ready LED flashes
and then remains illuminated.
If the test fails for a mechanical fault, the Drive Error
LED flashes while the Ready LED is illuminated.
For any other failure, the Drive Error and Tape Error
LEDs flash, while the Ready and Clean LEDs are
off. This continues until the drive is reset.

Completing the installation

1. If necessary, install the tape drivers.
If you installed tape drivers before
connecting the tape drive (Windows
only)
The tape drive should be detected
automatically and the correct drivers used.
If the Windows Found New Hardware
wizard runs, cancel it and then use Device
Manager to verify that the driver is
installed.
If tape drivers are not installed
(Windows only)
If you have not already installed drivers,
the Windows Found New Hardware
wizard will run when you power on the
server and tape drive. Follow the
on-screen instructions to search for the
required driver on the server. If necessary,
download the driver from the support
website:
http://www.hpe.com/support/hpesc
If tape drivers are not installed (other
operating systems)
Drivers are included with the operating
system and should be loaded
automatically. To upgrade drivers, Hewlett
Packard Enterprise recommends
upgrading to the latest version of the
operating system.
NOTE:
require their own Tape driver instead of
the Tape driver included with the
operating system.
2. Install Library & Tape Tools (L&TT) and then
use it to verify that the tape drive installation
was successful.
L&TT is designed to diagnose any issues when
using tape drives. Use it to confirm that the
tape drive is installed and functioning correctly
before you use the tape drive for backup. L&TT
is available without charge at:
http://www.hpe.com/support/tapetools
3. Download and install any operating system
upgrades necessary for the backup application.
Page 3
Certain backup applications