Endress+Hauser RIA 550 Betriebsanleitung Seite 70

Procesaanwijsinstrumen
CAL Kalibratie van de hulppunten
DADJ Helderheidsinstelling van de beide
Dot-Matrix displays
(alleen bij 2 kanaalsversie)
RTMP Aanwijzing interne referentie
temperatuur.
(alleen bij multifunktie ingang)
68
Multifunktie ingang:
Ingangsbereik spanning: bipolair
+/-20 mV, +/-50 mV, +/-100 mV, +/-200 mV,
+/-1 V, +/-2 V, +/-5 V, +/-10 V; Ri = 1MΩ
Ingangsbereik stroom:
0/4..20 mA; Ri = 50Ω
Ingangsbereik thermokoppels:
Typ L -200..+900 °C; Typ U -200..+600 °C;
Typ B 200..+1820 °C; Typ S 0..+1800 °C;
Typ R -50..+1800 °C; Typ K -200..+1372 °C;
Typ J -210..+1200 °C; Typ T -270.. +400 °C;
Typ N -270..+1300°C
Ingangsbereik RTD weerstandsopnemers:
Ni100 -60..+180°C; Pt100 -100..+600°C;
Pt500 -100..+600°C; Pt1000 -100..+600°C
Instelbare eenheden:
"OFF", "bar", "C/kg", "cal", "cd", "cm", "cm2",
"cm3", "dB", "G", "g/h", "g/l", "g/m3", "g/ml",
"g/s", "gal" , "HZ", "kg/s", "km/h", "kPa", "kV",
"kVar", "kW", "kWh", "kΩ", "l", "l/h", "l/s", "lb/h",
"lm", "m", "m/h", "m/s", "m/s2", "m3/d", "m3/h",
"m3/s", "mbar", "mg/l", "mm", "mm2", "mm3",
"MPa", "mPa", "mR/h", "ms", "mΩ", "MΩ", "mV",
"Mvar", " MW", "MWh", "N", "N/m2", "Nm", "oz",
"pH", "ppb", "ppm", "rem", "s", "t", "t/s", "V",
"VA", "Var", "Vol%", "Wh", "Ω", "µA", "µF", "µm",
"µs", "µS", "µΩ", "µV", "% ", "°C"
0 % 0 %-hulppunt
20 % 20 %-hulppunt
50 % 50 %-hulppunt
80 % 80 %-hulppunt
100 % 100 %-hulppunt
SAVE Afregelwaarden overnemen en bewaren
- 4 = bovenste display donkerder
onderste display helderder
+ 4 = bovenste display helderder
onderste display donkerder
xx °C
Bedienmatrix