Philips hd 3600 Bedienungsanleitung Seite 22

ENGLISH
22
Problem
Too much foam comes out of the appliance.
The beer that comes out of the appliance is flat.
The foam head collapses very quickly.
The temperature on the display goes up.
The keg fell, can I still use it?
It is difficult to place the tube into the tap unit.
The beer tastes bad.
Solution
The beer is too warm.Wait until the appliance has cooled
the beer to a temperature of 4cC or below. Check the
display for the temperature of the beer.The appliance
should not be exposed to direct sunlight and should be
placed in an environment with an ambient temperature
between 3c and 25c.
The keg has been shaken too much.Wait half an hour for
the beer to settle.
Make sure that the tap is completely open while tapping.
The first glass can contain more foam than usual.Try
pouring a second or third glass.
The tube may not function properly. Contact the Philips
Customer Care Centre in your country.
The keg is empty. Place a new keg into the appliance (see
chapter 'Replacing the keg').
Check if the keg has been open for over 28 days and check
if the sell-by date of the keg has expired.
The glasses used were not clean enough. Rinse the glasses
with water and some washing-up liquid. Rinse them
thoroughly with cold water to remove all grease and soap
residues.
The appliance should be plugged in all the time to keep
the beer in the opened keg cool.The temperature shown
on the display should be 4cC or below.
Pour beer as described on the keg and in these instructions
for use.
Do not let the spout touch the glass, the beer or the beer
head.
The glasses used were not clean. Rinse the glasses with
water and some washing-up liquid. Rinse them thoroughly
with cold water to remove all grease and soap residues.
Make sure the beer is cold and the display shows a
temperature of 4cC or below.
Place the appliance in an environment with an ambient
temperature between 3cC and 25cC and leave at least
10 cm free space behind and on both sides of the
appliance. Do not expose the appliance to direct sunlight.
When it is an unopened keg and it does not have any
visual damage, you can try to use it.When the keg has
already been opened, you cannot use the keg anymore.
Make sure you clean the tap unit with hot water before
inserting a new tube.
Pour a glass of beer from the opened keg at least every
7 days.
Always clean the tap unit and place a new tube into it
when you install a new keg.
Make sure you use clean glasses.