How To Set Each Indoor Unit - LG V-net PQNUD1S00 Bedienungs- Und Montageanleitung

How to set Interface unit

How to set each Indoor Unit

■ Using wired remote controller
AUTO SWING OPERATION
Timer Operation unit
On Off
Set no. Time 01
Timer Cancel
Program Week
Program
Hour Min
3. Press the "Program" & "Setup/Clr" keys at the same time
for 3 seconds to set up the indoor address.
• The room address on the PDI is listed in the ascending order of indoor number.
Ex) If the indoor addresses are "7C", "7D", "7E" and "7F", the order of the indoor unit on the
PDI are "1", "2", "3" and "4".
• The indoor numbers must be entered in sequence to be accurately recognized in the PDI.
Ex) Correct indoor unit address setup: "01", "02", "03" (setup in order)
Incorrect indoor unit address setup: "01", "02", "06"
20 Electricity Distribution Indicator
SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED Defrost Humidify
JET
LO Filter Out door
Time ZONE 1 2 3 4
Program set
03 05 07 09 11 13 15 17 19 21
Holiday
Plasma
Set/Clr
RESET
Set/Clr
1. Press the "Program" &
"Set/Clr" keys at the same
time.
23
2. Set up the indoor address
using the temperature
adjustment key
☛ Setup range: 00-7F
3 A
Group No. Indoor No.