Preparation; Supplied Accessories; Assembly - Sony UP-DR100 Gebrauchsanweisung

Preparation

Supplied Accessories

Make certain you have received the following
accessories:
Paper Scrap Tray (1)
Power Cord (1)
CD-ROM (1)
Operating Manual (1)
Software License Agreement (1)
Warranty Card (1)
Service and Customer Support
Information (1)
Notes
• When taking out the printer, be careful not to hurt your
back.
• The packaging materials are needed when
transporting the printer, so we suggest you keep them.
• Before moving the printer, remove the ink ribbon and
paper.
34
Supplied Accessories

Assembly

Mount the paper scrap tray on the printer.
Paper scrap tray
To remove the Paper scrap tray
Hold both ends of the paper scrap tray and pull it
forward while pushing it down.
To accumulate the ejected printed sheets
Use of the UPA-DR100PS PRINT STACKER (not
supplied) is recommended. Printed sheets for up to one
roll can be accumulated on the stacker regardless of the
type of printing pack used.
Caution
When the UPC-R57/R57A/R68A printing pack is used,
check the location where the printer has been installed.
A space of about 20 cm (7
printer, and about 20 cm (7
bottom of the printer is required as shown in the
diagram.
Match the front edge of
the printer to the edge
of the installation rack.
7
7 / inches
8
7
7 / inches
8
If there is not enough space (as shown in the illustration
above), ejected printed sheets may pile up and clog at the
Paper Output Slot and trouble may occur.
7
/ inches) out from the
8
7
/ inches) down from the
8