Special Safety Information; Overview Of The Components; Start-Up Of The Device/Introduction; Listening To The Radio - AEG SR 4356 BT Bedienungsanleitung

English
36

Special safety information

This device works with a class 1 laser.

Overview of the Components

1 Telescopic antenna
2 CD compartment
3 OPEN/CLOSE button
4 TUNING control
5 /PAIR button
6 button
7 PROG/P-MODE button
8 / buttons
9 Display
10 PAIR/STANDBY control lamp (bluetooth/operating status)
11 - FOLD./10+ buttons
12 BAND button
13 FUNC. button
14 /STANDBY button
15 VOLUME control
16 USB port
17 AUX-IN input
Reverse (not shown)
AC Mains connection
Underside (not shown)
Battery compartment

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC on the back of the
machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD tray (2) by pressing the OPEN/CLOSE but-
ton (3).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
You can adjust the desired volume with the VOLUME control
(15).
Turning device on/ off
• Press the /STANDBY button (14) to turn the device on.
• To turn off the device, press the /STANDBY button
again. The control lamp PAIR/STANDBY (10) lights up
red.
NOTE:
After about 15 minute without a signal, the device will
automatically switch to standby.

Listening to the Radio

1. Select the radio mode with the FUNC button (13).
2. Completely extend the telescopic antenna. Change its
position to improve the reception. An antenna is inte-
grated to receive AM stations. By turning and adjusting it,
the device can be aligned to the station. Programs in this
frequency band are only broadcast in mono.
3. Select the desired frequency band with the BAND button
(12).
FM = Frequency modulation, AM = Medium wave
4. Tune the desired station with the TUNING control (4). For
FM stations, the notification "STEREO" will appear on
the display if the station is received in stereo.