Battery operation
NOTE
►
For battery operation, use 3 x 1.5 V AA/Mignon/LR6 batteries (included).
►
When the battery level is low, the
Replace the batteries as soon as possible.
♦
Using a Phillips screwdriver, loosen the screw of the battery compartment
on the back of the appliance.
♦
Remove the cover of the battery compartment
♦
Insert the batteries into the battery compartment
the battery compartment
♦
Close the cover of the battery compartment
Mains power operation
♦
Connect the supplied mains adapter
appliance and to a mains socket.
After the power supply has been established, both halves of the illuminated
area
The appliance is in standby mode.
Inserting and changing the motif disc
The motif disc with one image
The motif disc with two images
♦
Place the motif disc in the depression so that the two tabs of the motif disc
slide into the two recesses on the edge of the illuminated area
♦
Turn the motif disc clockwise until it sits firmly on the front of the illuminated
area
♦
Turn the motif disc anticlockwise to remove it.
NOTE
►
Store the unused motif disc in the storage compartment
the appliance. To do this, push the motif disc from above behind the two
tabs.
SKS 4 A1
illuminate briefly, and the display
.
symbol flashes on the display
.
as indicated on the polarity diagram.
and tighten the screw again.
to the connection socket
switches on and shows a face.
is provided for use as a night light.
is intended for use as a sleep trainer.
. Place the batteries into
of the
.
at the rear of
GB │ MT
│
75
.
■