Silvercrest SEC 60 A1 Bedienungsanleitung Seite 28

• Only connect the power plug to a
properly installed, easily accessible
outlet, the voltage of which complies
with the information on the type label.
Even after connecting the power plug,
the outlet must be easily accessible.
• Ensure that the power cord can never
be damaged from sharp edges or hot
spots. Do not wrap the power cord
around the device, but coil it up in the
bottom of the device.
• Even after turning it off, the device is
not completely disconnected from the
power supply. You must unplug the
device to have it completely discon-
nected.
• When you set up the device, ensure
that the power cord is never jammed
or squashed.
• Ensure that children cannot pull the
device on the cable down from the
work surface.
• Always pull on the plug and not on the
cable to disconnect the power plug
from the socket.
• Unplug the power plug from the
socket...
... if there is a malfunction,
... when you do not use the ice
crusher,
... before you clean the ice crusher and
... during thunderstorms.
• This device is not intended to be oper-
ated with an external timer or a sepa-
rate telecontrol system.
• Immediately disconnect the power
plug from the socket in the case of
damages to the power cord or the
device.
• Do not use the device if it shows visi-
ble damages to the casing or the
power cord. To prevent hazards, do
not carry out any changes to the
device. Also, do not replace the power
cord yourself. Please have repairs
26
GB
only carried out by an authorised
service centre.
• Immediately unplug the power plug in
the event liquids or foreign materials
enter the device. Have the device
checked prior to using it again.
RISK of Injury
• Never reach into the running device
through the filler shaft. Do not insert
any items into the filler shaft. Also hold
long hair or loose clothing away from
the filler shaft. There is a risk of injury
due to the rotating knives of the crush-
ing mill.
WARNING about material damage
• Never place the device on hot sur-
faces (e.g. hot plates) or close to heat
sources or open fire.
• Do not exceed the maximum operat-
ing time of 10 minutes since otherwise
the device overheats which creates a
fire hazard.
• Let the device cool down for at least
2 minutes after each operation.
• Do not fill too much ice into the device:
The crushing mill may jam.
• In the case of jamming of the crushing
mill, immediately turn the device off
and wait until the ice in the filler shaft
has melted.
• Only use the original accessories.
• The ice crusher has been designed for
the sole purpose of crushing ice cubes
made of pure water.
• Ice cubes from fruit juices or with col-
our additives may not be crushed
since that can result in the crushing
mill becoming sticky or discoloured.
The ice crusher must never be used
for food of any sort. The leftovers can-
not be removed from the crushing mill.
• The appliance is fitted with non-slip
silicone feet. As furniture is coated