Pioneer DVD-D7563 Bedienungsanleitung Seite 8

A HARDWARE TOUR
TOP VIEW
0 Function switch
ON OFF
This switch is used to check the device before shipment,
and its setting should never be changed.
SCSI mode selection switch
OFF: SCSI-2 mode; burst transmission rate: 10 MByte/sec
ON: SCSI-3 mode; burst transmission rate: 20 MByte/sec
This switch is set off (SCSI-2 mode) at the time of shipment from the factory.
NOTE:
Ordinarily, we recommend using this unit with this switch left off (SCSI-2 mode).
If this switch is set on (SCSI-3 mode), the unit could malfunction, depending on
the connecting cables, usage environment, etc.
TO INSTALL THE DRIVE
Warning about static electricity
Always be sure never to touch the contacts or ports when operating drives.
Also be sure to touch a metallic surface on the changer before installing additional
drives to the changer.
For instructions on how to open the access doors, see the operating instructions for
the DRM-7000 disc changer.
Before installation, be sure to specify the following settings at the rear of each drive to
be installed.
SCSI ID assignment
Specify the SCSI IDs to be used so as to ensure that the same SCSI ID is not
assigned by more than one drive on the same SCSI bus.
Termination
Set the termination switch of the last drive in the SCSI chain to the ON position.
8
En
0