Installation - Klarstein Antarctica Handbuch

INSTALLATION

• After unpacking, carefully check the machine for damage during transport, then
remove the accessory, wipe the ice bucket with a clean damp cloth.
• This series of machines should be placed in the air circulation of clean places, not
open to the ground, should not be exposed to direct sunlight and rain, can not be
placed near the heat source.
• The ambient temperature of this series of machines should be no less than 3°C, not
higher than 40°C, around the appropriate spacing should be retained to maximize
the efficiency of ice and machine cooling.
Part
Side
Back
Front
• When installing the ice machine, please check the front and rear directions level.
• This series of machines is strictly prohibited to place the ice below the freezing
point of ice, otherwise it will produce serious failure.
Installation of Power
• The power supply should be the same as that on the machine nameplate
(220 V / 50 Hz or 380 V / 50 Hz).
• The power plug should be plugged directly into a power outlet with a ground wire
and not on a temporary terminal block. All lines must meet national or regional
standards.
• The voltage fluctuation must not exceed ± 10% of the rated voltage, otherwise the
regulator should be installed.
• The grounding of this series must meet the electrical standard.
Distance (cm)
15
20
50
EN
17