Standard Equipment - Hama F 700 / 76 Bedienungsanleitung

00062561bda 08.04.2002

STANDARD EQUIPMENT:

- 20 mm, 12.5 mm and 4 mm focal length – 0.965" diameter eyepiece
- 2X Barlow Lens
- Moon Filter
- Eyepiece adapter (24.5 – 31.7 mm)
TELESCOPE ASSEMPLY
1. Remove telescope from the carton and identify all components. READ THROUGH ASSEMPLY INSTRUCTION
BEFORE YOU ASSEMBLY YOUR TELESCOPE
2. Set-up Tripod
Select one tripod leg and extend the tripod Leg Middle Section (7). Using the Tripod Leg Lock Screw (10) inclu-
ded in the hardware pack, insert a Tripod Leg Lock Screw into the lower brackets on the Tripod Leg (6).
Tighten the Tripod Leg Lock Screws as that the Middle Section is securely in place. Repeat for the remaining
two legs.
3. Attach Telescope and Finderscope
Locate the pre-assembled Telescope Main Tube (14) and Altazimuth Yoke Mount (12).. Note: Before
assembling tripod legs to Altazimuth Yoke Mount, make sure the Accessory Tray Braces (8) face inward.
Locate the long bolts and washers from the hardware pack. Position the mount over the Tripod Leg (6) as sho-
wn (fig. 1) and align the holes in the Tripod Leg with the holes in the mount. Insert the bolts through the holes
at the top of a Tripod Leg. A washer should be positioned on both outer sides of the Tripod Leg. Attach a wing
nut to the bolt, but do not tighten it all the way. Repeat on the remaining two Tripod Legs. Once you have atta-
ched all Tripod Legs to the mount, securely tighten all wing nuts. Remove the Stabilizer Bar Mounting Screw
(11) from the hardware pack and insert it into the opening at the base af the Vertical Stabilizer Bar (4).
Locate ther Finderscope (1) with pre-assembled mounting bracket. Remove the two nuts located near the front
of the telescope (closest to the eyepiece) and place the Finderscope and bracket assembly over the exposed
screws. The Finderscope Focus Adjustment (16) should point towards the Primary Mirror (13). Replace the
nuts, and securely tighten the Finderscope and bracket assembly in place.
4. Attach Accessory Tray
Locate the Accessory Tray (9). Using the accessory tray bolts, wing nuts and washers connect the Accessory
Tray Braces (8). Start with one tripod leg and attach wing nuts. Wing nuts should be positioned beneath the
accessory tray. Do not tighten wing nuts until all Accessory Tray Braces are attached as some adjustments
may be required.
Your Telescope is now ready to be used. To obtain the fullest enjoyment from your telescope, please refer to
the additional information below.
Technical data:
Primary Mirror diam: 3" (76 mm)
Focal length: 700 mm
Eyepieces: 4 mm, 12.5 mm, 20 mm
Eyepiece survey and theoretical strengths:
Eyepiece Strength
4 mm 175 X
12.5 mm 56 X
20 mm 35 X
15:48 Uhr Seite 4
2X Barlow
Max. Magnification: 350X
Finderscope: 5X24 mm
Strength with 2XBarlow
350 X
112 X
70 X
4
L