Specifications; Important Safety Instructions - Makita AF550H Betriebsanleitung

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency (times/min.)
5. Locking position
6. Released position
7. Lock lever
8. Trigger
9. Contact element
10. Adjuster
11. Too deep
12. Flush
13. Too shallow
14. Lever

SPECIFICATIONS

Dimensions (L X H X W)
Min. hose diameter
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Wear safety glasses.
............. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for fastening on interior work and
furniture work.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
Explanation of general view
15. Sliding door
16. Magazine
17. Nail
18. Groove for the sliding door
19. Grooves at the bottom of the
magazine
20. Nail discharge opening
21. Front driver guide
22. Nose adapter
23. Protrusion
24. Holder
25. Nose adapter
26. Place first the contact element
against workpiece.
Model
Air pressure
Nail length
Nail capacity
Net weight
• Always wear safety glasses to protect your eyes from
END106-2
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or nail injury. The safety glasses
and the face shield should conform with the
requirements of AS/NZS 1336.
WARNING:
ENE073-1
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
(Fig. 1)
• Wear hearing protection to protect your ears against
ENB110-1
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when under
the influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
(1) Always assume that the tool contains fasteners.
(2) Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
27. Holder
28. Hex wrench
29. Rear driver guide
30. Screws
31. Humid
32. Hot
33. Cap
34. Drain cock
35. Air filter
36. Oiler
37. Pneumatic oil
38. Thinner
39. Stove
AF550H
0.98 - 2.26 MPa (9.8 - 22.6 bar)
15 mm - 55 mm
100 pcs.
228 mm X 61 mm X 235 mm
5.0 mm or more
1.3 Kg
7