Herunterladen Diese Seite drucken

Blaupunkt SJV301 Bedienungsanleitung Seite 7

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
SJV301
1. Bowl
2. Filter
3. Auger
4. Lid
5. Pulp container
BEFORE FIRST USE
1.
Remove all papers, cartons, foil which secure the juicer and juicer parts.
2.
Clean the juicer following the advice in Cleaning and Maintenance chapter.
3.
It is recommended to assemble and disassemble the juicer before using.
ASSEMBLING THE JUICER AND DISASSEMBLING
1. Place the squeezing bowl (1) on the body of the device, make sure that the three tabs will enter the
holes in the bowl. Then lock the bowl by turning it clockwise.
2. Insert the filter (2) into the squeezing bowl (1). Note the position of the arrows on the filter (2) and
the bowl (1).
3. Insert the auger (3) inside the squeezing bowl with the filter and turn it until it settles well.
4. Put the lid (4) on the bowl (1) and turn it clockwise until it snaps into place.
5. Place the pulp container (5) under the residue drain nozzle and the juice cup (6) under the juice
outlet.
FOOD PREPARATION
Remove stones (plums, peaches, cherries etc).
Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
Soft-skinned and other foods just need washing.
Cut the food into smaller pieces to fit the feed tube.
USING THE DEVICE
Switch on, put some fruits and vegetables into the feeder and push down with the pusher.
Use reverse (R) function only when food get stuck. Do not turn the switch quickly from ON to R, but
wait a few seconds in the OFF position.
Some very hard foods may make your juicer slow down or stop. If this happens switch off and unblock
the filter.
Insert soft food slowly to get the most juice.
Some fruits and vegetables may block filter during work which cause decrease of the juicing efficiency.
If you observe that during work, efficiency is getting to low, cleaning of filter is needed.
CLEANING AND MAINTENANCE
For easy cleaning - immediately after each use rinse removable parts under running water (to remove
wet pulp). Allow parts to dry.
After disassembling the unit all removable parts may be washed in hot soapy water.
The lid, bowl, pulp container, juice cup are dishwasher safe.
Wipe the motor base with a damp cloth.
Always treat the filter (2) with care as it can be easily damaged.
6. Juice container
7. Pusher
8. Cleaning brush
9. Switch (R, Off, ON)
5

Werbung

loading