Bosch DCU 220 Instandsetzungsanleitung Seite 25

4.4 Recovery process
i
The recovery process should be started if:
R
the Windows 7 operating system does not start.
R
The default windows settings should be set up
again.
!
All of the data and applications on your hard disk are
deleted during the recovery process!
!
Make sure the voltage supply must not be interrupt-
ed during the recovery process.
1. Connect the DCU 220 to the power supply unit.
2. Switch on the DCU 220.
3. If the following screen appears while the system
is starting, hold down the keys Ctrl + Alt + F2 for 4
seconds.
4. To start the recovery, select <Recovery> in the
screen which appears.
i
The progress bar shows the percentage of complet-
ed recovery. When 100% is reached, the system
turns off.
Robert Bosch GmbH
5. Switch on the DCU 220.
 The windows Setup Wizard starts.
6. Follow the instructions on the screen.
i
When the system restarts, the installation screen ap-
pears. The installation program identifies the system
hardware and installs the drivers.
"
After installation is over, the system restarts and the
Windows desktop appears.
| DCU 220 | 25 en
|
1 689 975 264 2015-06-02