English - IKEA BEKANT Bedienungsanleitung

ENGLISH

This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction
concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Advice and instructions for BEKANT
sit/stand desk.
Sound level: lower than 55 dB(A)
Height setting interval:
EU-version: 64-125 cm
NA-version: 57,4-122,4
Maximum load: 70 kg
Temperature interval at usage:
+5 up to +40 degrees C
Temperature interval at storage:
-10 up to +50 degrees C
Humidity:
20% up to 80% at +30 degrees C.
Power supply unit:
DC 25-35V, 240W
Manufacturer: ROL ERGO
Model:
EA11022-350 or ASW0579-2902002W
This appliance shall only be used together
with the included power supply unit.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions close to
your sit/stand table.
Installation instructions
─ The table is assembled according to
separate assembly instructions.
─ Connect the cable from one leg to the
other. Connect the hand control to one
of the leg and the power-supply to the
other leg. The cables to the legs, hand
control and power supply should be
placed in the accompanying net. Place
the electrical cables so that they do not
get damaged, see assembly instruction.
─ Connect the electrical cable to a wall
socket. NB! The electrical cable must
have full mobility.
─ Insert the safety key in the socket on
the hand control.
─ The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
─ The table shall only be used as a
working table with the possibility to
continuously adjust working height
between sitting and standing position.
The table shall only be used indoors and
in dry premises (office environment or
similar).
─ The table must not be overloaded -
maximum load is 70 kg. The motors
may be run continuously for maximum
1 minutes. Afterward, the motors must
stand by for approx. 9 minutes before
they can be used again.
Follow these instructions when
adjusting table height:
1. Insert the safety key in the socket on
the hand control.
4