Setting The Reference Point Output Signal Width - Sony MJ700 Bedienungsanleitung

3-4-4. Setting the reference point output
signal width
The width of the reference point output signal can be changed
by MODE switch 4 (reference point mode switch).
MODE switch 4
(reference mode switch)
1/4 Z mode
The reference point signal is output in
ON
synchronization when both the A phase
and B phase are at the high level.
Z mode
The reference point signal is
OFF
output in synchronization during
the one cycle of the A phase.
The reference point output signal is output in both directions
with respect to the encoder travel direction. As a result,
differences in the reference point position may occur in the
travel direction.
Be sure to always use in the reading direction of the reference
point where the setting has been made.
Reference point output
signal width
(E) 19