Removing The Detector Attachment From The Insert - Siemens 5TC1 Series Bedien-Und Montageanleitung

6.2. Removing the motion detector attachment ' Komfort'
from the insert
When the motion detector attachment ' Komfort' is withdrawn
from the insert, the insert maintains its last switching state.
When plugged in again, the motion detector attachment ' Kom-
fort' shows the same reaction as after a mains failure of more
than 2 seconds.
This means that the motion detector attachment ' Komfort'
performs a self-test lasting approximately 90 seconds. During
this time, the lighting is on. After this period, the lighting is
switched off and the preset mode of operation is active.
Attention:
Withdrawing the motion detector attachment 'Komfort' from
the insert will cause the attachment to lose the stored
brightness threshold information.
68