Switching On And Off; Maintenance And Cleaning; Troubleshooting - Parkside PDMFW 15 A1 Originalbetriebsanleitung

NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding plate
► Ensure that the dust extraction holes of the
sanding plate and sanding sheet are flush .
Removal:
♦ Simply pull the sanding sheet off the sander
plate .

Switching on and off

Switching on:
♦ First, press the trigger lock
then the trigger
Switching off:
♦ Release the trigger
♦ When you have finished working, disconnect
the tool from the compressed air source .

Maintenance and cleaning

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes) . Avoid
all skin contact with these substances . If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis . If dust is
produced or swirled up during maintenance,
it can be inhaled .
NOTE
► To ensure correct functioning and a long
service life for the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning .
PDMFW 15 A1
, remove
forwards and
to switch the tool on .
.
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired .
.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk . In doubt, contact the
Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .

Troubleshooting

Fault
Speed too
slow, air
escapes from
the outlet .
Tool does
not move;
compressed
air escapes
completely
through the
outlet .
Possible Remedy
cause
Motor parts Check the
jamming due pressure
to dirt . supply filter
for contamina-
tion .
Pressure Check the
supply too pressure
low . supply filter
for contamina-
tion .
Lubricate the
tool as de-
scribed in the
instructions .
If necessary,
repeat the
steps outlined
above .
Motor is Lubricate the
jammed due tool as de-
to material scribed in the
build-up . instructions .
GB │ IE │ NI │ 11 ■