Hama Cube Bedienungsanleitung Seite 8

Note – Time zone
• The DCF signal can be received over long distances, but always transmits the current
Central European Time in Germany. Make sure you account for the time difference in
countries in other time zones.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that
you should set +3 for the time zone. The clock then sets the time automatically to 3
hours ahead after receiving the DCF signal or according to the manually set time.
Selecting 12 or 24-hour format
• Press the +/RCC button (10) to switch between the 12 and 24-hour formats.
Backlight
• Press the SNOOZE/LIGHT button (12) to light up the display for approximately 5
seconds.
5.3 Alarm clock
Setting the alarm time
• Press the ALARM button (8) to go to alarm mode.
• Press and hold the ALARM button (8) to set the alarm time for the alarm displayed.
The hours display begins to ash.
• Press the +/RCC button (10) or the -/°C/°F button (11) to select the hour for the
alarm time, and con rm your selection by pressing the ALARM button (8). The
minutes display begins to ash.
• Repeat the process to set the minutes for the alarm time.
• Press the ALARM button (8) repeatedly to go back to the time display.
• If you do not make an entry for 20 seconds, the device automatically exits the
settings mode and the settings you made are saved.
Activating/deactivating the alarm clock
• Press the Alarm button (8) repeatedly to activate/deactivate the alarm time.
• If the alarm is activated, the corresponding symbol
6
is displayed.