Velleman CARSFM2 Bedienungsanleitung Seite 6

Note: this feature only works when supported by the car radio!
Briefly press the MENU/REPEAT button 5 times. Use the
select sync mode.
Music input
• There are 3 ways to provide music files to the transmitter (see §7: file
organization):
1. using an SD-card. Slide the SD-card in the SD-card slot [C] (pins facing
down).
2. via a USB device. Connect the USB device to the USB connector [D].
3. through the 2.5mm mini jack. Plug the 2.5mm plug into the mini jack [E].
• Press and hold the MEM/SD-USB button for ±2s to switch between SD and
USB input.
Playback
• Set the volume on the transmitter to an average level. Press the
MENU/REPEAT button twice followed by the
the volume control on the radio to get the best signal quality.
• Press the button, to toggle between pause and play mode. In play mode,
press the or
or for ±2s to skip to previous or next folder (see §7: file organization).
• In playback mode, press and hold the
transmitter display between frequency or remaining play time.
• In playback mode, pressing and holding the MENU/REPEAT button for ±2s will
scroll through playback modes:
• 7 frequencies can be stored for quick access. First select the desired
frequency, than press the MEM/SD-USB button. Use the
select a memory address (1~7).
• To recall a stored frequency, press the MEM/SD-USB button repeatedly until
the desired frequencies is shown on the display.
RDS
• For music tracks that are provided through the USB-port and that contain an
ID3-tag, a car radio with RDS (Radio Data System) functionality will show the
track information on its display.
• Briefly press the MENU/REPEAT button 3 times. Use the
select the RDS display method and press the MENU/REPEAT button again.
NOR: display shows 8 characters
SCR: display scrolls with 1s interval
• Briefly press the MENU/REPEAT button 4 times. Use the
select the interval time under normal RDS display mode (2~6s) and press the
MENU/REPEAT button again.
Remote control
• Refer to the overview under §5 for key functions.
• Use the fast reverse ( ) or fast forward ( ) buttons to scroll back or forward
through the current track at increased speed (2x, 5x or 10x).
• To recall a stored frequency, press the FREQ HOTKEY button repeatedly until
the desired frequencies is shown on the display.
• To repeat only a certain section of a track, press the A
starting point and press the
between A en B will be repeated until the
23/12/2010
CARSFM2
buttons to skip to previous or next track. Press and hold
1x Shuffle mode
2x Repeat current track
3x Repeat current directory
4x Normal playback mode
B button at the desired end point. The section
or
button for ±2s to switch the
B button is pressed again.
6
or button to
buttons (7 levels). Use
or buttons to
or button to
or button to
button at the desired
©Velleman nv
Rev. 02