Repairs; Cleaning, Maintenance And Storage - Pepperl+Fuchs ecom Lite-Ex PL 30e Bedienungsanleitung

to remove any remaining pieces, and check the sealing ring for damage.
After this has been done, you can install a new disc and, if necessary, new
sealing rings. Only spare sealing rings of ecom instruments are allowed.
The sealing ring is positioned between the housing head and the disc (see
picture 1). When putting the housing head back on, ensure that the seal is
positioned properly on the disc. After installation, you should not be able
to see any part of the sealing ring through the opening where the beam is
emitted. If the inside of the torch head or lens is also damaged, the torch
should be sent to the manufacturer for repair.

9. Repairs

Repairs are to be conducted by ecom instruments GmbH or service centres
authorised by ecom instruments GmbH, because the safety of the unit
needs to be tested after repairs are implemented.
The actual repair report sheet can be downloaded from the service area at
www.ecom-ex.com.

10. Cleaning, maintenance and storage

• Only use a suitable cloth or sponge to clean the unit.
• Do not use any solvents or abrasive cleaning agents when cleaning.
• We recommended having the operation and lumen output of the device
checked by the manufacturer every two years.
• The batteries should be taken out of the unit if it is to be stored for
extended periods.
• The storage temperature should be within the permitted range of -30 °C
to +60 °C.
• It should be observed that the electrical performance of specific types
of Zinc-Manganese Dioxide (Zn/MnO
temperatures below the product specified ambient temperature range.
The datasheets for the specific manufacturer and type of battery used
should be consulted to see what the recommended ambient temperature
range of use is to achieve maximum battery performance"
10
) batteries are limited to ambient
2